Statistiques de Houle pour Anse Bertrand, Janvier: Toutes Houles – Tous Vents
The figure shows the variation of swells directed at Anse Bertrand over a normal January. It is based on 2372 NWW3 model predictions since 2007 (values every 3 hours). The wave model does not forecast surf and wind right at the shore so we have chosen the most applicable grid node based on what we know about Anse Bertrand. In the case of Anse Bertrand, the best grid node is 30 km away (19 miles).
The rose diagram illustrates the distribution of swell sizes and directions, while the graph at the bottom shows the same thing without direction information. Five colours show increasing wave sizes. The smallest swells, less than 0.5m (1.5 feet), high are coloured blue. These occurred only 59% of the time. Green and yellow illustrate increasing swell sizes and red represents the biggest swells, greater than >3m (>10ft). In each graph, the area of any colour is proportional to how often that size swell occurs.
The diagram indicates that the dominant swell direction, shown by the biggest spokes, was NNE, whereas the the prevailing wind blows from the E. Because the wave model grid is away from the coast, sometimes a strong offshore wind blows largest waves away from Anse Bertrand and out to sea. We lump these in with the no surf category of the bar chart. To keep it simple we don't show these in the rose plot. Because wind determines whether or not waves are clean enough to surf at Anse Bertrand, you can load a different image that shows only the swells that were predicted to coincide with glassy or offshore wind conditions. During a typical January, swells large enough to cause surfable waves at Anse Bertrand run for about 7% of the time.
IMPORTANT: Beta version feature! Swell heights are open water values from NWW3. There is no attempt to model near-shore effects. Coastal wave heights will generally be less, especially if the break does not have unobstructed exposure to the open ocean.