uk es it fr pt nl
Ballyconnell Notations
Qualité quand ça marche: 3.0
Consistance des Vagues: 3.0
Foule a l'Eau: 3.0

Général: 3.4

Voir toutes les 18 notations

Basé sur 1 vote. Voter


Surf Report Feed

Statistiques de Houle pour Ballyconnell, Février: Toutes Houles – Tous Vents

This chart describes the range of swells directed at Ballyconnell through a typical February and is based upon 2664 NWW3 model predictions since 2007 (values every 3 hours). The wave model does not forecast wind or surf right at the shore so we have chosen the best grid node based on what we know about Ballyconnell. In the case of Ballyconnell, the best grid node is 27 km away (17 miles).

The rose diagram illustrates the distribution of swell directions and swell sizes, while the graph at the bottom shows the same thing without direction information. Five colours illustrate increasing wave sizes. Blue shows the smallest swells, less that 0.5m (1.5 feet) high. These happened only 6% of the time. Green and yellow show increasing swell sizes and red illustrates highest swells greater than >3m (>10ft). In either graph, the area of any colour is proportional to how often that size swell happens.

The diagram indicates that the prevailing swell direction, shown by the largest spokes, was WNW, whereas the the dominant wind blows from the SW. Because the wave model grid is away from the coast, sometimes a strong offshore wind blows largest waves away from Ballyconnell and out to sea. We combine these with the no surf category of the bar chart. To avoid confusion we don't show these in the rose graph. Because wind determines whether or not waves are surfable at Ballyconnell, you can view an alternative image that shows only the swells that were expected to coincide with glassy or offshore wind conditions. Over an average February, swells large enough to cause good for surfing waves at Ballyconnell run for about 94% of the time.

IMPORTANT: Beta version feature! Swell heights are open water values from NWW3. There is no attempt to model near-shore effects. Coastal wave heights will generally be less, especially if the break does not have unobstructed exposure to the open ocean.