Statistiques de Houle pour Anse Bertrand, Juin: Toutes Houles – Tous Vents
The figure illustrates the variation of swells directed at Anse Bertrand through an average June and is based upon 2306 NWW3 model predictions since 2006 (values every 3 hours). The wave model does not forecast surf and wind right at the coast so we have chosen the most applicable grid node based on what we know about Anse Bertrand. In this particular case the best grid node is 30 km away (19 miles).
The rose diagram shows the distribution of swell directions and swell sizes, while the graph at the bottom shows the same thing without direction information. Five colours represent increasing wave sizes. Very small swells of less than 0.5m (1.5 feet) high are shown in blue. These were forecast only 90% of the time. Green and yellow show increasing swell sizes and largest swells greater than >3m (>10ft) are shown in red. In both graphs, the area of any colour is proportional to how often that size swell was forecast.
The diagram indicates that the prevailing swell direction, shown by the longest spokes, was NNE, whereas the the most common wind blows from the E. Because the wave model grid is offshore, sometimes a strong offshore wind blows largest waves away from Anse Bertrand and away from the coast. We group these with the no surf category of the bar chart. To avoid confusion we don't show these in the rose graph. Because wind determines whether or not waves are good for surfing at Anse Bertrand, you can load a different image that shows only the swells that were predicted to coincide with glassy or offshore wind conditions. In a typical June, swells large enough to cause clean enough to surf waves at Anse Bertrand run for about 0% of the time.
IMPORTANT: Beta version feature! Swell heights are open water values from NWW3. There is no attempt to model near-shore effects. Coastal wave heights will generally be less, especially if the break does not have unobstructed exposure to the open ocean.